ANALISIS PERENCANAAN GEDUNG PERPUSTAKAAN STAIN PAREPARE DENGAN MENGGUNAKAN MODIFIKASI METODE FLAT SLAB

  • Mustakim Mustakim Universitas Muhammadiyah Parepare
  • Saing Muhammad
Keywords: etabs, PERENCANAAN GEDUNG

Abstract

The Analysis of Library Building Plan of Sekolah Tinggi Agama Islam Parepare by using A Modication of Flat Slab Method.

The research aimed to know the dimensions of main structure, create construction structure using at slab based on ETABS Program that was analyzed according to SNI 2847:2013. Counting the reinforcement needed by main structure and create a nal design based on the modication result of Library Building as well as analyze the mass participation in earthquake areas.

The analysis result showed that the thickness of the whole flat floor was 22 cm and drop panel was 120 cm x 120 cm with 12 cm thick, column dimension K1 for Floor 1 with 70/70, K1 floor 2-4 with 60/60, K1 floor 5 with 50/50, column 2 floor 1-5 with 50/35 and K3 floor 1-5 with 30 x 30, the thickness of shear wall was 30 cm. The reinforcement of flat slab produced reinforcement D16 mm, main column reinforcement K1 22D22, column K2 9D22, column K8D12. Final Plan of library building modification based on technical drawing form consisted of the Picture of structure plan, pieces, and detail of the reinforcement. In earthquake area with Category C, it was showed by mass partition control on mode 4 and 5 had achieved 93% and 94% and was able to restrain the load of earthquake plan.

References

Anggara, Wahyu P. Sabarimang, Bambang. 2018. Pengaruh Persentase Coakan Pada Denah Bangunan Struktur Flat Slab Terhadap Gaya Geser Dan Simpangan. Jurnal Ilmiah Teknik Sipil, Vol. 1, No. 1. ISSN: 2252-5009.

Asroni, Ali. 2010. Balok dan Pelat Beton Bertulang Edisi Pertama. Yogyakarta : Graha Ilmu.

AS, Jaka S. Wahyuni, Endah. 2012. Modifikasi Perancangan Struktur Menggunakan Flat Slab Pada Gedung Hotel PKPRI Trunojoyo Kota Sampang. Jurnal Teknik POMITS, Vol. 1, No. 1.

Badan Standardisasi Nasional. 2012. SNI 1726:2012 Tata Cara Perencanaan Ketahanan Gempa Untuk Struktur Bangunan Gedung dan Non Gedung. Jakarta : Badan Standardisasi Nasional.

Badan Standardisasi Nasional. 2013. SNI 2847:2013 Persyaratan Struktural Untuk Bangunan Gedung. Jakarta : Badan Standardisasi Nasional.

Depertemen Pekerjaan Umum. 1987. SKBI – 1.3.53.1987 Pedoman Perencanaan Pembebanan Untuk Rumah Dan .

Gunadi. R, Budiono. B, Imran. I, dan Sofyan A. 2012. Studi Eksperimental Perilaku Hubungan Pelat-Kolom Terhadap Kombinasi Beban Gravitasi dan Lateral Siklis. Jurnal Teknik Sipil ITB, Vol. 19, No. 3. ISSN 0853-2982.

Munawar, Moch C. 2014. Kajian Struktur Bangunan Gedung Politeknik Perkapalan ITS Dengan Sistem Plat dan Balok Biasa Konvensional Dibandingkan Sistem Struktur Flat slab Dengan Drop Panel Ditinjau Dari Estetika, Biaya Dan Waktu. Jurnal Teknik Sipil Untag Surabaya, Vol. 7, No. 1. P-ISSN 1693-8259.

Syamsi, Muhammad I. 2015. Perbandingan Analisis Two Way Slab With Beam Dengan Flat Slab (Studi Kasus: Coal Yard PLTU Kalimantan Barat). Jurnal Ilmiah Semesta Teknika, Vol. 18, No.2.

Tambusay, Asdam. 2014. Studi Eksperimental Perilaku Hubungan Pelat-Kolom Menggunakan Drop Panel Dengan Serat PVA-ECC Terhadap Beban Siklik Lateral. Prosiding Konferensi Nasional Pascasarjana Teknik Sipil (KNPTS). ISSN 2407-1021

Published
2021-09-02
Section
Articles